Select Page
Welcome to our Knowledge Base

Can I connect an Antec flow cell to another brand ECD?

You are here:
< All Topics

Applies to

Electrochemical flow cell


Technically, Antec flow cells can be connected to any controller that supports a 3-electrode flow cell. Never connect metal tubing directly to the cell, use at least 15 cm of PEEK or Teflon tubing in direct contact with the cell. Disclaimer: cells that are used in non-Antec detectors are not covered by warranty. Antec detectors are equipped with a Faraday shielded, oven compartment that warrants stable and reproducible detection conditions.

Was this article helpful?
0 out Of 5 Stars
5 Stars 0%
4 Stars 0%
3 Stars 0%
2 Stars 0%
1 Stars 0%
How can we improve this article?
How Can We Improve This Article?
Table of Contents