Select Page

How strongly must I tighten the flow cell bolts?

| Celle, controlli e manutenzione, Cells, checks and maintenance, Cellules, contrôles et entretien, Células, comprobaciones y mantenimiento, Zellen, Kontrollen und Wartung

Skip to main content
Welcome to our Knowledge Base

Updated
You are here:
< All Topics

Applies to

VT03 flow cells

Answer

Cell bolts of a VT03 cell and a µPrepCell are tightened using the factory supplied hex key. Over-tightening may cause an increased noise level. The bolts are tightened ‘a bit more than finger tight’. For cleaning, maintenance and installation of flow cells see flow cell manual.

Was this article helpful?
0 out Of 5 Stars
5 Stars 0%
4 Stars 0%
3 Stars 0%
2 Stars 0%
1 Stars 0%
5
How can we improve this article?
How Can We Improve This Article?
Table of Contents